MODEL 6 & Model 2

SIX channel amplifier

400w per channel @ 8 ohms

600w per channel @ 4 ohms

750w per channel @ 2 ohms
1200W @ 8 Ohms Bridged

1500W @ 4 Ohms Bridged

all channels driven

Balanced XLR & TRS ¼” Inputs

Bridged switches

Ground Lift switch

Dual temperature activated fans

“Soft Clip” circuitry

4 Rack space

Three independent power supplies

Amplifier Module Specifications

Frequency Response: +/- 0.25dB 20Hz – 20kHz

Distortion: No more than 0.1%THD or IM, 0.01W to rated output, 20Hz-20kHz (Typically 0.01%)

Hum & Noise: 101dB below rated output (unweighted, 20kHz bandwidth)

Input Sensitivity: 1.0VRMS for rated output (selectable - .775V, 1.0V, 1.5V)

Input Connectors: ¼” Phone Jack (Balanced) XLR (Balanced)

Output Connectors: 5-way Binding posts

Controls & Indicators (Front Panel) Ac mains power switch (breaker), power on LED, level controls, signal/clip LED’S, (Rear Panel) ground lift switch, stereo/bridge switches per each two channels,

Damping Factor: 500:1 @ 1kHz

Slew Rate: Closed-loop response greater than 40V/us

Crosstalk: -80dB

Gain: 34dB

Mainframe Power Supply: Toroidal transformer, 3 separate power supplies w/ 6ea 15k/uf capacitors

Turn-On Delay: 3 seconds

Power Requirements: AC Mains 100-240VAC, (120VAC from factory, unless otherwise indicated) 50/60Hz, 32A/16A for 2 Ohm, 20A/10A for 4 Ohm

Thermal Protection: Each channels thermal sensor activates channel shutdown if an over-heating condition exists.

DC Protection: DC sensor activates channel shutdown if DC condition exists.

Heatsink and Cooling: 3 State fan, off-low-high two speed cooling fan utilizing heatsink extrusions, Quiescent amplifier ON condition has no fan. Fans do not engage until heavy usage conditions.

Construction: 14-gauge cold-rolled steel with 3/16” heavy aluminum front panel

Dimensions: Slim line 7”height, 19” standard rack mount width, 16 ½” depth overall (less handles)

TWO channel amplifier